when I try to take a WDL and import it into my workspace, I try to set the root-entity-type to be pair, but even if I select pair, it goes back to participant.
I don't think I saw this before and I've even observed the issue with WDLs that have successfully run before.
To replicate the issue, I go to my workspace. I go to the method-configuration tab, and then I hit the "Import Configuration..." button. Next, I find a method (a WDL and not a config), and then I click on it. Then, I try to change the root entity type from participant to pair. But after I select, pair, the value resets to participant!
See the drop-down in the attached screenshot and it shows the drop-down I refer to where I observe this.
This was confusing at first. It is not a blocker however. To get around the issue, I import the config to have the root-entity-type of "participant", then I go to the imported config and then hit "Edit Configuration" and set the root-entity-type there and then, the "pair" selection sticks even after I save.
Has anyone else observed, replicated, or experienced this issue?